Lion Brand^® Trellis^® - Incredible^®

GAUGE:

Exact gauge is not essential to this project.

TRELLIS WRAPPED ORNAMENT

Push one pin into styrofoam ball ("north pole"), then push another into the ball directly opposite from the first ("south pole"). These points are for reference. Place end of Trellis at one pin and wrap yarn to other pin, then back to beginning point. Repeat all the way around ball so that entire ball is covered once with Trellis, overlapping yarn always at top and bottom points (at pins). Styrofoam will still be visible since the yarn has a "window" effect. Repeat so that Styrofoam is no longer visible – this may take 2-3 layers. Since overlapping occurs at top and bottom, the ball will be slightly oblong after wrapping. Cut and glue end down. Cut a strand of yarn 6½ inches [16.5 cm] long or desired length. Glue both ends to top of ornament for hanging loop.

INCREDIBLE WRAPPED ORNAMENT WITH TRELLIS TRIM

Push one pin into Styrofoam ball (“north pole inches), then push another into the ball directly opposite from the first (“south pole inches). These points are for reference. Place end of Incredible at one pin and wrap ball to other pin, then back to beginning point. Repeat all the way around ball so that entire ball is covered with Incredible, overlapping yarn always at top and bottom points (at pins). Cut and glue end down. Cut a strand of yarn 6½ inches [16.5 cm] long or desired length. Glue both ends to top of ornament for hanging loop. Cut 3 strands of Trellis approximately 8 inches [20.5 cm] long. Wrap first strand horizontally around center of ball ("equator") and glue into place. Repeat for 2 other strands, placing one above and one below first strand.