Loom Configuration Use the following pieces: (2) 36-hole pieces, (2) 12-hole pieces, (2) 6-hole pieces, (4) corner pieces.
Connect pieces to form a rectangle as follows: 36-hole piece > corner piece > 12-hole piece > 6-hole piece > corner piece > 36 hole piece > corner piece > 12-hole piece > 6-hole piece > corner piece.
Insert 38 small pegs into every hole along each long side and 21 small pegs into every hole along each short side of assembled loom - 118 working pegs placed.
Insert one contrast color small peg in upper right hand corner for slip knot.
NOTES
1. Warp is set up along the 21 small pegs placed along each short side of assembled loom.
2. Weft is set up along the 38 small pegs placed along each long side of assembled loom.
CLUTCH
Note: Follow loom manual instructions on WEAVING for how to set up the warp, weave the weft, and remove weaving from the loom.
FINISHING
Fold piece to about 4 1/2 x 6 1/4 in. (11.5 x 16 cm), with a 3 in. (7.5 cm) flap.
Thread yarn needle provided with loom with a strand of yarn and sew sides. With yarn ends threaded through same needle, weave ends into the fabric of the clutch. |
